a.Before installing the glass to carefully clear the debris inside the slot, such as mortar, brick debris, wood, etc., should be carefully placed on the glass, the gap on both sides to ensure a uniform and fixed promptly corrected, to prevent the collision shift, departing from the notch center.

       b.Rubber seal can not pull too tight, cutting length longer than the length of the assembly 2O-3Omm. When installing the mosaic in place, flat surface, and glass notch in close contact with the periphery of the glass even by force. In the corner of the rubber strip should be beveled off and disconnect the injection of glue at the firm.

       c.When caulking sealant fixed glass, you should use rubber or rubber block glass and choked, leaving a void plastic injection, plastic injection depth should not be less than 5mm, before the glue cured, the glass should be kept free from vibration.

       d.Mounting portion is generally tops in the window (door) fan, surrounded by sealing bridge or box fan (windshields block), the enhanced sealing between the frame and the fan

       e.Tops specification is an important factor affecting the performance of the sliding doors and watertight, an important factor also affect WINDOW SWITCH force. Specifications tops too large or hair shaft is too high, not only difficult to assemble, and to make your Windows Mobile resistance increases, especially in the larger initial resistance turned resistance and the last place closed. Size is too small, not enough height or vertical tops, easy-out outside the tank, the sealing performance of windows and doors greatly reduced. Subject to silicidation tops, tops acceptable quality exterior surface flat, smooth floor and vertical hair, no bending, no pitting on the floor, compliance of 0.2mm.